轉輪除濕機在啟動時需要做什么檢查？

　　轉輪除濕機在啟動時需要注意做好哪些檢查工作呢？下面的內容我們就來告訴您。

　　確保除濕設備接通電源，機組處于待機狀態時，設備控制箱上的電源指示燈應亮。設備安裝有自動控制，請將設備選擇就地操作模式。

　　接通電源，電源指示燈亮。

　　點動電動機，檢查風機轉向是否正確，若有誤即停機將相線調換，致風機正向。當點動時各部位應無異常現象和摩擦聲后方可投入試運轉3~5分鐘，停機。無異常再次試運轉，以鉗形表測量風機、電機的起動電流，運行電流是否正常。

　　檢查再生風機及處理風機的旋轉方向是否正確，正確的旋轉方向應該與風機機殼上所標的箭頭方向一致。

　　檢查轉輪的旋轉方向是否正確，正確的旋轉方向應該與轉輪箱體上所標的箭頭方向一致。

　　檢查所有設備啟、停和聯鎖裝置工作的可靠性。

　　英文版：

　　What inspection work should be done when the rotary dehumidifier starts? Let's tell you the following.

　　Ensure that the dehumidifier is connected to the power supply. When the unit is in standby state, the power indicator on the equipment control box should be on. Equipment installation has automatic control. Please select the local operation mode.

　　Turn on the power and the power indicator light is on.

　　Spot the motor to check whether the fan is steering correctly. If there is a mistake, stop the machine and change the phase line, causing the fan to be positive. When there is no abnormal phenomenon and frictional sound, all parts should be put into trial operation for 3~5 minutes before stopping. No abnormal test run again, with the clamp meter to measure the fan, motor starting current, running current is normal.

　　Check that the rotation direction of regenerative fan and treatment fan is correct. The correct rotation direction should be the same as the arrow direction marked on the fan housing.

　　Check that the rotation direction of the runner is correct. The correct rotation direction should be the same as the arrow direction on the runner box.

　　Check the reliability of all equipment startup, shutdown and interlocking devices.